TECHNICAL SUPPORT

Our technical knowledge on use of the information below is
the result of extensive research and long experience :
Please contact us for an optimal resolution of the problem.

series  FP 60/... NI  with cappings made of stainless steel
expansion joints for floors
(specific when resistance to chemical aggression is required)

Material:
Aluminium side plates with perforated aluminium mounting brackets and central "T" piece.
With rolled-on U-profile made of rust-resisting special steel.

Flexible insert made of high quality synthetic rubber, long wearing, weather resistant, temperature resistant (-30ºC to +120ºC), extensively resistant to oils, acids and bitumen.



Standard colour black
Production length 4 m

Special Properties:

  • Synthetic rubber insert replaceable at any time and can be installed in lengths up to 20 m
  • Good fixing by perforated mounting brackets.
  • Profile absorbs settlements
  • Positive connection of production length profile by staggering the joints in the individual aluminium profiles


Profile Joint width
max
mm
Total
movement
mm
Visible
width
mm
Total
width
mm
Installation height
(fixed)
mm
FP 60/4500 Ni 50 20 (± 10 ) 60 192 45
FP 60/5500 Ni 55
FP 60/6500 Ni 65
FP 60/8000 Ni 80
FP 60/9000 Ni 90
FP 60/10000 Ni 100

These profiles are also available for  fitting adjacent to corners - types E1,
E3 and E4

For installation in asphalt
Please contact our Technical Department

Load capacity:
Suitable for loads by private cars up to 30 kN; lorries (DIN 1072) up to 300 kN (not for permanent use); fork lift trucks (DIN 1055) up to 35 kN (not for permanent use).
Load capacity is only guaranteed if installation instructions are followed scrupulously.

 

Installation instructions