TECHNICAL SUPPORT
Our technical knowledge on use of the information below is
the result of extensive research and long experience :
Please contact us for an optimal resolution of the problem.
expansion joints for floors
(specific for valuable floors and when resistance to chemical aggression is required)
 |
 |
Material:
Aluminium side plates with perforated aluminium mounting brackets.
With rolled-on U-profile made of brass.
Flexible insert made of high quality synthetic rubber, long wearing, weather resistant, temperature resistant (-30ºC to +120ºC), extensively resistant to oils, acids and bitumen.
| Colour | black, grey |
| Production length | 4 m |
Special Properties:
- Synthetic rubber insert replaceable at any time and can be installed in lengths up to 20 m
- Good fixing by perforated mounting brackets.
- Profile absorbs settlements
- Positive connection of production length is obtained by slide-in connecting pins.
- Suitable for floors with high loads (brass’ hardness 1/3 superior to aluminium’s one; wearing resistance similar to steel)
- Highly resistant to neutral and alkali salts, industrial ambiance, saltness, acids, etc
| Profile | Joint width max mm |
Total movement mm |
Visible width mm |
Total width mm |
Installation height (fixed) mm |
|---|---|---|---|---|---|
| BS 55/2100 MS | 50 | 16 (± 8) | 57 | 150 | 21 |
| BS 55/2600 MS | 26 | ||||
| BS 55/3600 MS | 36 | ||||
| BS 55/5100 MS | 51 | ||||
| BS 55/7600 MS | 76 |
These profiles are also available for
fitting adjacent to corners - types
E1,
E3 and E4
Load capacity:
Suitable for loads by private cars up to 30 kN; lorries (DIN 1072) up to 300 kN (not for permanent use).
Load capacity is only guaranteed if installation
instructions are followed scrupulously.
