
TECHNICAL SUPPORT
Our technical knowledge on use of the information below is
the result of extensive research and long experience :
Please contact us for an optimal resolution of the problem.
expansion joints for floors
(specific when resistance to chemical aggression is required)
![]() |
![]() |
Material:
Aluminium side plates with perforated aluminium mounting brackets.
With rolled-on U-profile made of rust-resisting special steel.
Flexible insert made of high quality synthetic rubber, long wearing, weather resistant, temperature resistant (-30ºC to +120ºC), extensively resistant to oils, acids and bitumen.
Standard colour | black, grey |
Production length | 4 m |
Special Properties:
- Synthetic rubber insert replaceable at any time and can be installed in lengths up to 20 m
- Good fixing by perforated mounting brackets.
- Profile absorbs settlements
- Positive connection of production lengths is obtained by slide-in connecting pins.

Profile | Joint width max mm |
Total movement mm |
Visible width mm |
Total width mm |
Installation height (fixed) mm |
---|---|---|---|---|---|
BS 55/2100 Ni | 50 | 16 (± 8) | 57 | 150 | 21 |
BS 55/2600 Ni | 26 | ||||
BS 55/3600 Ni | 36 | ||||
BS 55/5100 Ni | 51 | ||||
BS 55/7600 Ni | 76 |
These profiles are also available for
fitting adjacent to corners - types
E1,
E3 and E4
For installation in asphalt
Please contact our Technical Department
Load capacity:
Suitable for loads by private cars up to 30 kN; lorries (DIN 1072) up to 300 kN (not for permanent use).
Load capacity is only guaranteed if installation
instructions are followed scrupulously.
Installation instructions