Our technical knowledge on use of the information below is
the result of extensive research and long experience :
Please contact us for an optimal resolution of the problem.

series  FS 200/... - MIGUTRANS
expansion joints for floors passable by heavyweight fork list trucks
(especially suitable for factories, warehouses, airports, railway stations)

For joints width up to 6 cm - load capacity 130 kN (DIN 1055)

Principle of operation:
MIGUTRANS profiles, all aluminium construction, have been designed for movements joints in floors to be used by four wheels lift trucks and fork lift trucks (transpallets).
Articulated telescopic systems, two-piece bridging unit, allow absorption of movements in three directions.

Colour aluminium
Production length 4 m

These profiles are also available for fitting adjacent to corners – type E3 and E4 (connection floor-wall)

Special Properties:

  • Visible surface has no gaps, prevents dirt accumulation
  • Good slip resistance is given by surface grooving
  • Profile absorbs settlements and movements
  • Good fixing by perforated mounting brackets, spacing 30 cm, screwed to the base at the side of the joint by means resin bonded anchors, alternatively in external and intermediate holes of brackets
  • Positive connection of production length profiles by staggering the joints in the individual aluminium profiles and/or by slide-in connecting pins (for profiles with h=25mm).
  • Possibility of connecting planes at different levels.

Load capacity:

  • Fork lift trucks (DIN 1055) up to 130 kN (contact surface of wheel 20x20 cm.)
  • Fork lift trucks and pallet trucks with tires made of solid plastic (polyamide, Vulkollan) with allowed axle load according to diagram (*)
  • Suitable for pallet trucks (transpallet).
  • Vehicles (DIN 1072) up to 600 kN.

Load capacity is only guaranteed if installation instructions are followed scrupulously.

Diagram (*)
admissible load

Profile Joint width
Installation height

FS 200/4500 60 40 (± 20 203 284 25
FS 200/4500 45