
TECHNICAL SUPPORT
Our technical knowledge on use of the information below is
the result of extensive research and long experience :
Please contact us for an optimal resolution of the problem.
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
Material:
High quality synthetic rubber, long wearing, weather resistant, temperature resistant (-30ºC to +120ºC), extensively resistant to oils, acids and bitumen
Standard colour | black, grey |
Special Properties:
-
The permanent elasticity and the special design of the side barbs ensure secure fixing and good watertightness
-
Very good sound insulation and thermal insulation by special design of the profiles (8 hollows)
-
Intersections are created with ease (see drawing in installation instructions).
Profile | Joint width max mm |
Joint depth min. mm |
Total movement mm |
Production length mm |
---|---|---|---|---|
FB 20/1518 | 10 | 25 | 6 | 20 |
FB 20/1820 | 12 | |||
FB 20/21/22 | 15 | 30 | 7 | 20 |
FB 20/2422 | 18 | |||
FB 20/3028 | 20 | 35 | 12 | |
FB 20/4030 | 28 | 45 | 14 | 20 |
FB 20/5038 | 35 | 55 | 20 | |
FB 20/6048 | 45 | 65 |
Installation instructions:
Clean the joint and apply our special adhesive Kleber with a flat brush or a spray gun to the sides of the joint.
Press the FB 20 profile into the joint by hand pressure until it is correctly entered, then push finally home with a caulking tool to the required depth.
Jointing of lengths of profile is done by means of a scarf joint. In making 4-way intersections the profiles are cut to form
a halved joint so that they fit closely together.
If it is necessary for the profile to be inserted and bent round a right angle corner the profile must be reduced in depth by removing all four cross pieces for an area at least as long as the total depth of the profile.
Silicone mastic should be applied to all exposed ends of the cross pieces and then the sections pushed together in such a way that a full seal is obtained.
